pDC IN 12V terminal
DC 12 V (maximum DC 17 V) power input connector.
e Screw holes for external battery attachment |
Attach external battery for DC 12 V power supply |
by using 2 screw holes. Choose the appropriate |
screw holes from 1, 2 or 3 according to the type of |
external battery. |
Attaching the power cord holder
The provided power cord holder prevents accidental disconnection of the AC power cord from the AC IN terminal.
• The power cord holder consists of two parts, a case and a cover.
When using DC 12 V power (maximum DC 17 V), check the DC IN 12V terminal pin signal, and use the correct polarity. If the polarity is reversed, this could cause a fire or personal injury.
•While using both the AC and DC 12 V power supply, AC power supply is preferentially used. If the AC power supply is cut off (for example, when turning off the POWER switch), the power supply automatically switches to the DC 12 V power supply.
• Use the Anton Bauer Dionic 90 (mount: QR DXC- |
M3A) external battery. |
CAUTION
• | Do not use the external battery for DC 24 V |
| power supply. |
• | Use only the battery specified above. If a heavy |
| battery is used, it may fall off depending on the |
| way the monitor is used. |
• | When an external battery is attached, attach the |
| ferrite core (provided) to the power cord from the |
| mount as illustrated below. |
1 | 2 | 3 |
| AC IN | Cover |
|
| |
| terminal |
|
Case
CAUTION
To detach the cover
qAC IN terminal
AC power input connector.
Connect the provided AC power cord to an AC outlet.
•Attach the provided power cord holder to prevent accidental disconnection of the AC power cord. (☞ “Attaching the power cord holder” on page 9)
wPOWER switch
Turns AC power on or off.
•You need to press button (☞ u on page 6) to use the monitor after turning on the POWER switch.
Ex.: When the Anton Bauer mount (QR |
is used |
Ferrite core
rSecurity slot
Attach a security wire to this slot.
Note for connections
•Before making any connections, turn off all the equipment.
•Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
•Plugs should be firmly inserted; poor connections could cause noise.
•When unplugging a cord, be sure to grasp its plug and pull it out.
•DO NOT connect the power cord until all connections are complete.
•Refer also to the user manual of each piece of equipment.
•Use only the provided screws.
•Make sure the plug will not be pulled out after the cover is attached to the case.
ENGLISH9