JVC DT-V17G1 specifications Daily Operations / Connections cont, Rear panel

Daily Operations / Connections (cont.)

7Rear panel

Carry handle

Use this handle when carrying the monitor.

e

1REMOTE terminal

Terminal for controlling the monitor by an external control. (☞ “External Control” on page 20)

2VIDEO terminals (BNC)

Input (IN) and output (OUT) terminals for the composite video signals.

3COMPO. (Y, PB/B-Y, PR/R-Y) terminals (BNC) Input (IN) and output (OUT) terminals for the analog component video (color difference) signals.

4AUDIO (IN) terminals (pin jack)

Input terminals for the analog audio signals.

•Use this terminal for the analog audio connection of the SDI. When a superimposed signal (EMBEDDED AUDIO signal on an SDI signal) is input, analog audio signals cannot be input.

5AUDIO (MONITOR OUT) terminals (pin jack) Output terminals for the analog audio signal.

•The terminals emit the audio signals through the AUDIO (IN) terminal or EMBEDDED AUDIO signals through the E. AUDIO HD/SD SDI (IN 1 or IN 2) input terminal.

•The signal is output from this terminal only when the monitor is on or in “P.SAVE” (power

rsave) mode. (☞ “NO SYNC ACTION” in “SYNC FUNCTION” on page 15)

•The EMBEDDED AUDIO signal...

–is decoded into an analog signal, then emitted.

–is emitted only when “SDI 1” or “SDI 2” is selected, and when EMBEDDED AUDIO signals come in to the E. AUDIO HD/SD SDI (IN 1 or IN 2) terminal.

8

6E. AUDIO HD/SD SDI (IN 1, IN 2) terminals (BNC) Input terminals for the HD/SD SDI signals.

•The terminals accept also EMBEDDED AUDIO signals including up to 12 audio channels with a sampling frequency of 48 kHz.

•Use both terminals when selecting DUAL LINK SDI for the input.

7E. AUDIO HD/SD SDI (SWITCHED OUT) terminal (BNC)

Output terminal for the HD/SD SDI signals.

•The SDI signals of the current input (SDI 1 or SDI 2) are re-clocked, then emitted.

•When an input other than SDI 1 and SDI 2 is selected, the SDI signal of the input selected last time is emitted from this terminal.

•The signals are emitted from this terminal only when the monitor is on or in “P.SAVE” (power save) mode.

•No signals are emitted when DUAL LINK SDI is selected for the input.

8DVI-D (HDCP) terminal

Input terminal for the DVI-D signal compatible with HDCP.

•When the picture is not displayed correctly, change the setting of “DVI INPUT SEL.” (☞ page 19).

9DC switch

Turns the DC 12 V power on or off.

•You need to press button (☞ u on page

6) on the front panel to turn on the monitor after turning on the DC switch.

•The monitor consumes the battery even while the monitor is on standby. To save battery life, turn off the DC switch.

CAUTION

Do not connect the power cord until all other connections are completed.