Daily Operations / Connections cont, Rear panel, POWER switch

Daily Operations / Connections (cont.)

7 Rear panel

Note for connections

• Before making any connections, turn off all the equipment.

• Use a cord whose plugs correctly match the terminals on this monitor and the equipment.

• Plugs should be firmly inserted; poor connections could cause noise.

• When unplugging a cord, be sure to grasp its plug and pull it out.

• DO NOT connect the power cord until all connections are completed.

• Refer also to the user manual of each piece of equipment.

CAUTION

Do not connect the power cord until all other connections are completed.

1POWER switch

Turns the AC power on or off.

•You need to press button on the front panel to turn on the monitor after turning on the POWER switch.

2AC IN terminal

AC power input connector.

•Connect the provided AC power cord to an AC outlet.

•Attach the provided power cord holder to prevent accidental disconnection of the AC power cord (☞ page 9).

3DC switch

Turns the DC 12 V power on or off.

•You need to press button on the front panel to turn on the monitor after turning on the DC switch.

•The monitor consumes the battery even while the monitor is on standby. To save battery life, turn off the DC switch.

4 DC IN 12V terminal DC 12 V (maximum DC 17 V) power input connector.

When using DC 12 V power (maximum DC

17 V), check the DC IN 12V terminal pin signal, and use the correct polarity. If the polarity is reversed, this could cause a fire or personal injury.

•While using both the AC and DC 12 V power supply, AC power supply is preferentially used. If the AC power supply is cut off (for example, when unplugging the AC power cord), the power supply automatically switches to the DC 12 V power supply.

5VIDEO/COMPONENT terminals (BNC)

IN: Input terminals for the composite (VBS) and the analog component (Y/PB/PR) signals.

•Select the signal type in “VIDEO/COMPO. SEL.” corresponding to the type of the input signal (☞ page 10).

OUT: Output terminal for the composite (VBS) and the analog component (Y) signals.

6AUDIO terminal (pin jack)

IN: Input terminal for the analog audio signals.

•Use this terminal for the analog audio connection of the SDI.

OUT: Output terminal for the analog audio signals to the AUDIO IN terminal.

7E. AUDIO HD/SD SDI terminal (BNC)

IN: Input terminal for the HD/SD SDI signals.

•The terminals accept also EMBEDDED AUDIO signals* including up to 12 audio channels with the sampling frequency of 48 kHz.

OUT: Output terminal for the HD/SD SDI signals.

•The signals are re-clocked, then emitted from this terminal.

•The signals are emitted only when the monitor is on or in P.SAVE (power save) mode.

8REMOTE terminal

Terminal for controlling the monitor by an external control.

☞ “External Control” on page 14

9Carry handle

Use this handle when carrying the monitor.

pSecurity slot

Install a security wire to this slot.

qScrew holes for external battery attachment Attach external battery for DC 12 V power supply by using 2 screw holes. Choose the appropriate screw holes from 1, 2, 3 or 4, according to the type of external battery.

•Use the Anton Bauer Dionic 90 (mount: QR DXC- M3A) external battery.