JVC GET0483-001A manual Check the battery system in your car, Prepare this before installation

KD-S35

Installation/Connection Manual

Manual de instalación/conexión

GET0563-002A

[J]

ENGLISHESPAÑOL

PREPARATIONS

You need the installation kits which corresponds to your car.

• Mark all the check boxes ( ) to make sure you have follow the instructions and the listed parts.

Check the battery system in your car

12 V DC, NEGATIVE ground

Prepare this before installation

0508DTSMDTJEIN EN, SP

© 2008 Victor Company of Japan, Limited

TROUBLESHOOTING

•The fuse blows.

* Are the red and black leads connected correctly?

•Power cannot be turned on. * Is the yellow lead connected?

•No sound from the speakers.

* Is the speaker output lead short-circuited?

•Sound is distorted.

*Is the speaker output lead grounded?

*Are the “–” terminals of L and R speakers grounded in common?

•Noise interfere with sounds.

* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

•This unit becomes hot.

*Is the speaker output lead grounded?

*Are the “–” terminals of L and R speakers grounded in common?

•This unit does not work at all. * Have you reset your unit?

Parts list for installation and connection

A/B	C	D	E
Hard case/	Sleeve	Trim plate	Power cord
Control panel
F	G	H	I
Direct connection	Washer (ø5)	Lock nut (M5)	Mounting bolt—
cable for iPod			M4 × 5 mm (M4 × 1/4");
			M5 × 12.5 mm (M5 × 1/2")
J	K	L	M
Rubber cushion	Handles	Remote controller	Battery
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.

In dash-mounting

Removing the unit

Before removing the unit, release the rear section.

Do the required electrical connections.

When you stand the unit, be careful not to damage the fuse on the rear.

Bend the appropriate tabs to hold the sleeve firmly in place.

When using the optional stay

Fire wall Stay (option)

Dashboard

Screw (option)

Install the unit at an angle of less than 30˚.

When installing the unit without using the sleeve

In a Toyota car for example, first remove the car radio and install the unit in its place.

Flat type screws	* Not supplied for this unit.
—M5 ⋅ 8 mm (M5 ⋅ 3/8")*
Bracket*
	Flat type screws
Pocket	—M5 ⋅ 8 mm (M5 ⋅ 3/8")*
Bracket*

1