ELECTRICAL CONNECTIONS

Make sure to disconnect the battery’s negative terminal.

• Be sure to ground this unit to the car’s chassis again after installation.

Note:

It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS).

High

Heat sink

Typical connections

Antenna terminal

Rear line out

Rear ground terminal

15 A fuse iPod connector

Ignition switch

Connect only the front speakers if your

Black

To metallic body or

 

 

chassis of the car

speaker system is two-speaker system.

 

 

 

White with black stripe

 

To a live terminal in the

Yellow *2

fuse block connecting to the

 

 

 

 

 

car battery (bypassing the

Front speaker (left)

White

 

ignition switch) (constant

 

12 V)

 

 

 

 

 

 

Fuse block

Gray with black stripe

Red

To an accessory terminal in

 

 

Front speaker (right)

Gray

 

the fuse block

 

 

Green with black stripe

Blue with white

To the remote lead of other

 

 

stripe

 

 

equipment or automatic antenna if

 

 

 

Rear speaker (left)

Green

 

any (200 mA max.)

 

 

Purple with black stripe

 

 

Rear speaker (right)

Purple

 

 

PRECAUTIONS on power supply and speaker connections

Connecting the external amplifiers and/or subwoofer

 

Remote lead

Y-connector *1

Set “L/O MODE” to “REAR”

Remote lead (blue with white stripe)

(See page 15 of the

 

 

 

 

 

To the remote lead of other equipment

INSTRUCTIONS.)

 

 

 

or automatic antenna if any

JVC Amplifier

Rear speakers

Front speakers

or

Set “L/O MODE” to “SUB. W” (See page 15 of the INSTRUCTIONS.)

Remote lead

JVC Amplifier

Subwoofer

*1 Not supplied for this unit.

*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.

*3 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place not coated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*4 Signal cord (not supplied for this unit).

Connecting an Apple iPod

You can connect an iPod to this unit using the supplied direct connection cable for iPod.

iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

Apple iPod (separately purchased)

Direct connection cable for iPod (supplied)

2

Page 138
Image 138
JVC GET0483-001A manual Precautions on power supply and speaker connections, Set L/O Mode to Rear, JVC Amplifier