JVC GR-AXM4U manual Recording Mode Setting, Loading/Unloading a Cassette

SP/EP

Set POWER to “CAMERA”

		4	3
	1	5	2
1

Turn to take up slack.

Erase Protection Gear

13

Recording Mode Setting

1 Pressing SP/EP alternates the setting between SP (standard play-provides higher picture and sound quality, better for dubbing) and EP (Extended Play- more economical, recording at 1/3 the speed of SP).

NOTE:

If the recording mode is switched during recording, the playback picture will be blurred at the switching point.

Loading/Unloading A Cassette

OPEN LCD MONITOR

1 Press PUSH/OPEN and open the LCD monitor to an angle of over 60 degrees.

OPEN CASSETTE HOLDER

2 Press EJECT until the holder opens. Do not use force to open.

INSERT/REMOVE CASSETTE

3 Make sure the label is facing outward.

CLOSE CASSETTE HOLDER

4 Press PUSH and make sure the holder is closed and locked.

CLOSE LCD MONITOR

5 First make sure the holder is closed. Then close the LCD monitor.

NOTES:

●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor.

●A cassette holder can’t be opened unless a power supply is attached.

●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.

●Make sure the Erase Protection tab is present. If not, cover the hole with adhesive tape. (Some cassettes have sliding tabs – in this case, check the tab's position.)