EN13
Power Switch Position
(Manual) : Allows you to set various recording functions using the Menus. If you want more creative capabilities than Full Auto recording, try this mode.
(Full Auto) : Allows you to record using NO special effects or manual adjustments. Suitable for standard recording.
OFF | : | Allows you to switch off the camcorder. |
| : | Allows you to play back a recording on the tape. |
F . AUTO
When the Power Switch is set to “ 
”, “F. AUTO” appears.
When set to “ 
” or “ 
”, there is no indication.
NOTES:
●When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, use the viewfinder instead.
●The image will not appear simultaneously in the LCD monitor and the viewfinder .
●The cassette holder cannot be opened unless a power supply is attached.
●There may be a delay after you open the cassette holder cover until the cassette holder opens. Do not use force.
●Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.
●The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette at its end is loaded.
●If the 
” or “ 
”.
●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to “Recording from the middle of a tape” (☞ pg. 17).
●During recording, sound is not heard from the speaker.
●To turn the tally lamp off during recording, ☞ pg. 20, 21.
●To remove the indications from the camcorder’s display during recording, ☞ pg. 20, 23.
JOURNALISTIC SHOOTING
In some situations, different shooting angles may provide more dramatic results. Hold the camcorder in the desired position and tilt the LCD monitor in the most convenient direction. It can rotate 270° (90° downward, 180° upward).
SELF-RECORDING
You can shoot yourself while viewing your own image in the LCD monitor. Open the LCD monitor and tilt it upward 180° so that it faces forward, then point the lens toward yourself and start recording.
