30 EN

RECORDING Advanced Features (cont.)

Fade/Wipe Effects

These effects let you make pro-style scene transitions. Use them to spice up the transition from one scene to the next. You can also vary transitions from scene to scene.

IMPORTANT:

Some Fade/Wipe Effects cannot be used with certain modes of Program AE with special effects ( pg. 32). If an unusable Fade/Wipe Effect is selected, its indicator blinks or goes out.

START/STOP Button

MODE Dial

POWER Switch

Lock Button

Operation Switch

MENU Wheel

To Deactivate The Selected Effect . . .

.... select “OFF” in step 4.

NOTES:

You can extend the length of a Fade or Wipe by pressing and holding START/STOP.

If the power is turned off after a scene is finished recording, the stored point is erased, disabling the Picture Wipe/Dissolve combina- tion. When this happens, the Picture Wipe/ Dissolve indicator blinks. Also note that power shuts off automatically if 5 minutes elapse in the Record-Standby mode.

Picture Wipe/Dissolve cannot be used when the MODE Dial is set to “ ”.

The sound at the end of the last recorded scene is not stored.

FADE/WIPE SELECTION (

,

,

,

,

,

,

,

,

and

)

 

 

 

Fade or Wipe works when recording is started or when you stop recording.

1 Set the POWER Switch to “ ” while pressing down the Lock Button located on the switch and the MODE Dial to “VIDEO” or “ ”, then set the Operation Switch to “ ”. Pull out the viewfinder fully or open the LCD monitor fully.

2 Press the MENU wheel. The Menu Screen appears.

3 Rotate the MENU wheel to select “ ”, then press it.

4 Rotate the MENU wheel to select the desired function, then press it. Selection is complete.

•The FADER/WIPE Menu disappears and the effect is reserved. The indicator representing the selected effect appears.

5 Press START/STOP to activate the Fade-in/out or Wipe-in/out.

PICTURE WIPE OR DISSOLVE SELECTION

( , , , , , and )

The Picture Wipe or Dissolve works when recording is started.

1 Follow steps 1 through 4 above.

2 Engage the Record-Standby mode.

If you select Picture Wipe/Dissolve during recording . . .

.... press START/STOP when one scene is finished.

The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode . . .

.... press START/STOP to start recording and press it

again when one scene is finished. The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode after performing a Picture Wipe/ Dissolve . . .

.... the point at which the scene ended is already

stored in memory.

3 If you start recording a new scene within 5 minutes of the end of the previous recording (without having turned the camcorder’s power off), the previous scene wipes out, revealing the new scene.

Page 30
Image 30
JVC GR-DVM80, GRDVM80U specifications 30 EN, Fade/Wipe Effects, FADE/WIPE Selection, Picture Wipe or Dissolve Selection