![](/images/new-backgrounds/1318396/318396143x1.webp)
72 EN | USING THE REMOTE CONTROL UNIT (cont.) |
Program
|
|
| I N | OUT | MODE | Random Assemble |
1 | – – | – |
|
| ||
2 |
| ~ |
|
| Editing Menu |
3~
4~
5~
6~
7~
8~
T I ME CODE –
TOTAL 0 0 : 0 0
Remote sensor
PLAY
FADE/WIPE EFFECT
EDIT IN/OUTR.A.EDIT
ON/OFF
CANCEL
SELECT SCENES
4 Point the remote control at the camcorder’s remote sensor. Press PLAY (4) and then press R.A.EDIT ON/ OFF on the remote control.
The Random Assemble Editing Menu appears.
5 If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE on the remote control.
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•You cannot use a Picture Wipe/Dissolve at the beginning of Program 1.
6 At the beginning of the scene, press EDIT IN/OUT on the remote control. The
7 At the end of the scene, press EDIT IN/OUT. The
8 If using a Fade/Wipe at the end of the scene, press FADE/WIPE.
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•If you select a Fade/Wipe effect for an
•You cannot use a Picture Wipe/Dissolve at the end of the last scene.
•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).
9
10 Repeat steps 6 through 9 to register additional scenes.
•To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.
•If you are not using Fade/Wipe or Program AE with special effects, repeat steps 6 and 7 only.
NOTES:
●When choosing a scene, set
●If the search time for an
●If there are blank portions before or after the
●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.
●Turning off the camcorder’s power erases all registered
●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next
●It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using a DV cable.