EN 25

1Make sure all units are turned off.

2Connect the camcorder to a TV or VCR as shown in the illustration. ( pg. 24)

If using a VCR, go to step 3. If not, go to step 4.

3Connect the VCR output to the TV input, referring to your VCR’s instruction manual.

4Turn on the camcorder, the VCR and the TV.

5Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

To choose whether or not the following displays appear on the connected TV…

Date/Time

Set “DATE/TIME” to “AUTO”, “ON” or “OFF”. ( pg. 48)

Or, press DISPLAY on the remote control to turn on/off the date indication.

Time Code

Set “TIME CODE” to “ON” or “OFF”. ( pg. 48)

Playback sound mode, tape speed and tape running displays for video playback

Set “ON SCREEN” to “LCD” or “LCD/TV”. ( pg. 48)

NOTE:

NOTES:

It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack. ( pg. 11)

To monitor the picture and sound from the camcorder without inserting a tape or memory card, set the camcorder’s Power Switch to “A” or “M”, then set your TV to the appropriate input mode.

Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

While the S/AV/Editing cable is connected to the S/AV connector, sound cannot be heard from the speaker.

How to connect the S/AV/Editing cable...

1)Align the guide pin at the end of the S/AV/Editing cable with the guide hole on the camcorder.

2)Insert the cable straight into the hole and neighboring S/AV connector.

3)To disconnect the S/AV/Editing cable, pull the cable straight out.

To S/AV connector

Guide hole

Guide pin

S/AV/Editing cable (provided)

Page 25
Image 25
JVC GR-DVP7U manual How to connect the S/AV/Editing cable