86 EN

 

TROUBLESHOOTING (cont.)

 

 

 

 

 

 

 

 

34.

Colored bright spots appear all

34.

•The LCD monitor and the

34.

 

 

 

over the LCD monitor or the

 

viewfinder are made with

 

 

 

 

viewfinder.

 

high-precision technology.

 

 

 

 

 

 

However, black spots or

 

 

 

 

 

 

bright spots of light (red,

 

 

 

 

 

 

green or blue) may appear

 

 

 

 

 

constantly on the LCD

 

 

 

 

 

monitor or the viewfinder.

 

 

 

 

 

 

These spots are not recorded

 

 

 

 

 

 

on the tape. This is not due to

 

 

 

 

 

 

any defect of the unit.

 

 

 

 

 

 

(Effective dots: more than

 

 

 

 

 

 

99.99 %)

 

 

 

 

 

 

 

 

 

 

35.

The indicators and the image

35.

•This may occur when the

35.

 

 

 

color on the LCD monitor are

 

surface or the edge of the

 

 

 

not clear.

 

LCD monitor is pressed.

 

 

 

 

 

 

 

 

 

 

36.

The cassette will not load

36.

•The cassette is in the wrong

36.

•Set it in the right position.

 

 

properly.

 

position.

 

( pg. 16)

 

 

 

 

•The battery’s charge is low.

 

•Install a fully charged battery.

 

 

 

 

 

 

( pg. 10, 11)

 

 

 

 

 

 

 

 

37.

The memory card will not load

37.

•The memory card is in the

37.

•Set it in the right position.

 

 

properly.

 

wrong position.

 

( pg. 17)

 

 

 

 

 

 

 

 

38.

The memory card cannot be

38.

38.

•Push in the memory card a

 

 

removed from the camcorder.

 

 

few more times. ( pg. 17)

 

 

 

 

 

 

 

 

 

 

 

39.

Picture does not appear on the

39. •The viewfinder is pulled out.

39. •Push the viewfinder back in.

 

 

LCD monitor.

 

•The LCD monitor’s brightness

 

•Adjust the brightness of the

 

 

 

 

setting is too dark.

 

LCD monitor. ( pg. 13)

 

 

 

 

 

 

•If the monitor is tilted

 

 

 

 

 

 

upward 180 degrees, open

 

 

 

 

 

 

the monitor fully. ( pg. 13)

 

 

 

 

 

 

 

 

40.

Images on the LCD monitor

40.

•The speaker volume is too

40.

•Turn the speaker volume

 

 

are jittery.

 

great.

 

down. ( pg. 22)

 

 

 

 

 

 

 

 

41.

The LCD monitor, the

41.

 

41.

•Wipe them gently with soft

 

 

viewfinder and the lens have

 

 

cloth. Wiping strongly can

 

 

become dirty (ex. fingerprints).

 

 

 

cause damage. ( pg. 91)

 

 

 

 

 

 

 

 

42.

Time code does not appear.

42.

•“TIME CODE” is set to

42.

•Set “TIME CODE” to “ON”.

 

 

 

 

“OFF”.

 

( pg. 38, 48, 51)

 

 

 

 

 

 

 

 

43.

An unusual mark appears.

43.

 

43.

•Check the section of the

 

 

 

 

 

manual that explains LCD

 

 

 

 

 

monitor/viewfinder

 

 

 

 

 

 

 

 

 

 

 

 

indications. ( pg. 96 – 99)

 

 

 

 

 

 

 

Page 86
Image 86
JVC GR-DVP7U manual 86 EN, Cause damage.  pg