Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
Display
Minutes
Seconds
Frames*
(25 frames = 1 second)
12 : 34 : 24
* Frames are not displayed during recording.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number.
To perform Random Assemble Editing ( pg. 41 – 44), time code is necessary. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform “Recording From The Middle Of A Tape” (see below) in the following cases;
●When shooting again after playing back a recorded tape.
●When power shuts off during shooting.
●When a tape is removed and
●When shooting using a partially recorded tape.
●When shooting on a blank portion located partway through the tape.
●When shooting again after shooting a scene then opening/ closing the cassette holder cover.
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON”. ( pg. 30)
Recording From The Middle Of A Tape
1)Play back a tape or use Blank Search ( pg. 18) to find the spot at which you want to start recording, then engage the Still Playback mode. ( pg. 17)
2)Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch, then start recording.
VIDEO PLAYBACK EN 17
Normal Playback
4/9 | Power Switch |
5
|
| Lock Button |
| |
3 | 8 |
|
| |
VIDEO/MEMORY |
|
| ||
| MENU VOL. +/– | Speaker |
| |
|
| PLAYBACK | ||
3 Set the Power Switch to “PLAY” while pressing down | ||||
1 Load a cassette. ( pg. 14) |
|
| ||
2 Set the VIDEO/MEMORY Switch to “VIDEO”. |
| |||
the Lock Button located on the switch. | & | |||
4 To start playback, press 4/9. |
| RECORDING | ||
5 To stop playback, press 8. |
|
| ||
● During Stop mode, press 3 to rewind, or 5 to fast- |
| |||
forward the tape. |
|
| ||
To control the speaker volume |
| VIDEO | ||
Press VOL. + to turn up the volume, or VOL. – to turn | ||||
| ||||
down the volume.
NOTES:
●The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV. ( pg. 18)
●If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To turn on again, set the Power Switch to “OFF”, then to “PLAY”.
●When a cable is connected to the AV connector, the sound is not heard from the speaker.
Still Playback
Pauses during video playback.
1)Press 4/9 during playback.
2)To resume normal playback, press 4/9 again.
●If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.
