JVC GR-X5EK, GR-X5EE manual Other problems

	MasterPage: Start_Right
GR-X5PAL.book Page 53 Thursday, April 7, 2005 7:23 PM
	TROUBLESHOOTING EN 53
Other problems	Images on the LCD monitor appear dark or
	whitish.

The POWER/CHARGE lamp on the camcorder does not light during charging.

●Charging is difficult in places subject to extremely

high/low temperatures.

HTo protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C. (
pg. 57)

●The battery pack is not attached firmly.

HDetach the battery pack once again and re-attach it firmly. (
pg. 13)

“SET DATE/TIME!” appears.

●The date/time is not set.

HSet the date/time. (
pg. 15)

●The built-in clock battery has run out and the previously set date/time has been erased.

HConsult your nearest JVC dealer for replacement.

Files stored in the memory card cannot be deleted.

●Files stored in the memory card are protected. HRemove protection from the files stored in the

memory card and delete them. (
pg. 28)

When the image is printed from the printer, a black bar appears at the bottom of the screen.

●This is not a malfunction.

HBy recording with “DIS” activated (
pg. 33, 34) this can be avoided.

When the camcorder is connected via the DV connector, the camcorder does not operate.

●The DV cable was plugged/unplugged with power turned on.

HTurn the camcorder’s power off and on again, then operate it.

When connected to the PC with a DV cable, the image data is not transferred.

●The VIDEO/MEMORY switch is set to “MEMORY”.

HSet the VIDEO/MEMORY switch to “VIDEO”.

●In places subject to low temperature, images become dark due to the characteristics of the

LCD monitor. This is not a malfunction. HAdjust the brightness and angle of the LCD

monitor. (
pg. 12, 16)

●When the LCD monitor’s fluorescent light reaches the end of its service life, images on the LCD

monitor become dark.

HConsult your nearest JVC dealer.

Coloured bright spots appear all over the LCD monitor.

●The LCD monitor is made with high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99%)

The cassette will not load properly.

●The battery’s charge is low.

HInstall a fully charged battery. (
pg. 13)

The memory card cannot be removed from the camcorder.

HPush in the memory card a few more times. (
pg. 17)

Picture does not appear on the LCD monitor.

●The LCD monitor’s brightness setting is too dark. HAdjust the brightness of the LCD monitor.

(
pg. 16)

An error indication (01 – 04 or 06) appears.

●A malfunction of some kind has occured. In this

case the camcorder’s functions become unusable.

H
pg. 56.

The remote control does not work.

●“REMOTE” is set to “OFF”.

HSet “REMOTE” to “ON”. (
pg. 33, 35)

●The remote control does not point at the remote sensor.

HPoint at the remote sensor. (
pg. 23)

●The remote control batteries are exhausted.

HReplace the batteries with fresh ones. (
pg. 23)

REFERENCES