JVC HD-DH40000U 56 EN, Input/Output settings [IN/OUT FUNCTION], VIDEO, VIDEO, VIDEO, NO CONV, signal:, S-VIDEO, S-VIDEO, S-VIDEO, 720to1080, ALLto480i, NO CONV.:, WIDE 16:9

56 EN OTHER USEFUL FUNCTIONS (cont.)

Input/Output settings [IN/OUT FUNCTION]			* The default setting is bold in the table below.
TV OUTPUT 1	Select the apppropriate mode when receiving signals via i.LINK connector or
720to1080	playing back a D-VHS tape containing a recording of an HD (High Definition)
NO CONV.	signal:
ALLto480i	720to1080:	720p is up-converted to 1080i and output to the TV. 1080i,
		480p, and 480i image formats are output to the TV without
		being converted. Select this when the 720p image played
		back is distorted.
	NO CONV.:	1080i, 720p, 480p, and 480i image formats are output to
		the TV just as they are.
	ALLto480i:	All images will be output to the TV in 480i image format.
	NOTE:
	When you receive signals via i.LINK connector or play back the picture of 1080i, 720p,
	480p image format, the signal is not output from the S-VIDEO or VIDEO output connector
	if “TV OUTPUT 1” is set to “720to1080” or “NO CONV.”.
TV OUTPUT 2	Select the apppropriate mode depending on the type of TV you have.
WIDE 16:9	WIDE 16:9:	Select this for a wide TV set with 16:9 screen image size.
NORMAL 4:3
	NORMAL 4:3: Select this for a TV set with 4:3 screen image size.
	NOTES:
	● When “TV OUTPUT 2” is set to “WIDE 16:9”, sometimes the screen image may be
	stretched vertically.
	● When “TV OUTPUT 2” is set to “NORMAL 4:3”, sometimes subtitles may not be visible
	or the ends of the screen image may be cut off. Normally select “WIDE16:9”.
	● In order to let the equipment determine the screen image size, it is recommended that
	you connect the VCR and TV using the component video output connectors or S VIDEO
	OUT connector.
FRONT AUX F-1	You have to select which terminal — either VIDEO (composite) or S-VIDEO (Y/C
VIDEO	separate signals) to use as the video input terminal on the front panel.
S-VIDEO	Make sure to select the correct terminal; otherwise, you may fail in recording
	(editing) on this VCR.
REAR AUX L-1	You have to select which terminal — either VIDEO (composite) or S VIDEO (Y/C
VIDEO	separate signals) to use as the video input terminal (L-1) on the rear panel.
S-VIDEO	Make sure you select the correct terminal; otherwise, you may fail in recording
	(editing) on this VCR.
REAR AUX L-2	You have to select which terminal — either VIDEO (composite) or S VIDEO (Y/C
	separate signals) to use as the video input terminal (L-2) on the rear panel.
VIDEO
S-VIDEO	Make sure you select the correct terminal; otherwise, you may fail in recording
	(editing) on this VCR.