EN 71

Changing

Remote Control

Code

POWER

PLAY (3)

IN F-1

+

15

2- 1

VCR CABLE

TV /DBS

2- 2

2- 3

NOTE:

When “POWER SAVE” is set to “ON”, you can not change the remote control code. Before changing the code, set “POWER SAVE” to “OFF” ( pg. 57).

The Remote is capable of controlling four JVC video recorders independently. Each of VCRs can respond to one of four codes (A, B, C or D).

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily change your Remote and the VCR to send and respond to B, C or D code signals.

When using four JVC VCRs, set four VCRs and their Remotes to different codes, so that the Remotes can operate these VCRs separately.

1 Set remote operation modeSet the VCR/TV/CABLE/DBS selector to “VCR”.2 Set remote control code for Remote1 Press and hold A/B/C/D.

2 Press the Number key “1” for A code control signals, “2” for B code control signals, “3” for C code control signals, “4” for D code control signals.

3 Press STOP ( 7 ), and release A/B/C/D.3 Turn off VCRPress POWER on the VCR.4Check remote control code for VCRPress PLAY (3) on the VCR for more than 5 seconds.●The code currently set appears on the front display panel.5TurnPress POWERon VCR on the Remote.

●The code transmitted from the Remote blinks for a few seconds on the front display panel.

●After the code disappears on the front display panel, make sure that the VCR is turned on by pressing POWER on the Remote.

To control four VCRs with the same Remote

You can control four JVC VCRs by switching the remote control code for the Remote between A, B, C and D ( step 2), keeping four VCRs to different control codes.

●Press the Number key “1” for A code control signals, “2” for B code control signals, “3” for C code control signals, “4” for D code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 3 to 5.)

(Ex.) To set Remote to B code:

STOP

A/B/C/D

Release

 

ABC

Hold

Press in succession

down