JVC HR-A230EK SET A/B Code Switch, RE-SUPPLY Power, Next Function Memory, Ntsc Playback

14

OPERATE	PLAY
	EW

q 6

OPERATE

A/B CODE	2
1	2	3
4	5	6
7	8	9
	0

REW

PLAY 3 1

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press OPERATE within 2 seconds.

PLAYBACK (cont.)

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY. “NT” appears on the display panel.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and elapsed tape time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.
	● Depending on the type of TV, the top and bottom
	portions of superimposed displays may be cut off
	during NTSC playback.

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

1	REMOVE POWER SUPPLY
	Unplug the mains power cord from the mains outlet.
2	SET A/B CODE SWITCH
	Set to B.
3	RE-SUPPLY POWER
	Plug the mains power cord back into the mains outlet.
4	TURN THE RECORDER ON
	Press OPERATE on the remote control. The recorder
	will now only respond to B code signals.

NOTE:

Some TV sets may malfunction in response to the B mode. If this happens, switch back to the A mode.