JVC HR-J311EU Select Channel to FINE-TUNE, Access Manual Channel SET Screen, Perform Tuning

40ENSUBSIDIARYSETTINGS(cont.)

Fine-Tuning Channels

Already Stored

Perform steps 1 and 2 of "Storing Channels Manually" on page 38 to access the Confirmation screen before continuing.

SELECT CHANNEL TO

FINE-TUNE

1 Press %Þ @ #until the channel you want to tune begins blinking.

ACCESS MANUAL

CHANNEL SET SCREEN

2 Press OK twice. The Manual Channel Set screen appears.

PERFORM TUNING

3 Press #until "+/–" begins blinking, then press %Þ until the picture is its clearest. Then press OK.

●The Confirmation screen appears.

●Repeat steps 1 through 3 as necessary.

CLOSE CONFIRMATION SCREEN

4 Press MENU.

Set Stations (A)

Set station names that are registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 38 to access the Confirmation screen before continuing.

1		SELECT ITEM
	Press %Þ @ #until the item you want begins blinking.
		ACCESS MANUAL
2		CHANNEL SET SCREEN
	Press OK twice.

	SELECT NEW STATION
	Press #until the station
	name (ID) begins blinking,
3 then press %Þ until the		PR CH ID FINE DECODER
	new station’s name (ID)	06 CH45 – – – – +/– OFF
	you want to store begins
	blinking.
	Registered station names	[5°] : CHANGE ID
	(☞ pg. 41) appear as you	[°°] : CURSOR +=
		: OK
	press %Þ.	[MENU] : EXIT
4	SWITCH STATIONS
	Press OK.

●The Confirmation screen appears.

●Repeat steps 1 through 4 as necessary.

CLOSE CONFIRMATION SCREEN

5 Press MENU.

Set Stations (B)

Set station names other than the ones registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 38 to access the Confirmation screen and then perform step 1 and 2 of "Set Stations (A)" on the left before continuing.

SELECT STATION NAME

CHARACTER

1	Press #until the first letter
		of the station name begins
		blinking.		PR	CH ID	FINE DECODER
				06	CH45 ARD	+/– OFF
				[5°] : A-Z, 0-9
				[°°] : CURSOR +=
					: OK
				[MENU] : EXIT
		ENTER NEW CHARACTER
	Press %Þ to cycle through the characters (A–Z, 0–9, –,
		*, +, (space) ) and stop when the desired character
2 is indicated, then press			#to enter. Enter the remaining
		characters the same way (maximum of 4).
		After entering all characters, press OK.

●The Confirmation screen appears.

●If you make a mistake, press @until the incorrect character begins blinking. Then enter the correct character by pressing %Þ.

CLOSE CONFIRMATION SCREEN

3 Press MENU.