JVC HR-J638E/EH specifications Activate Counter, Memory, SET A/B Code Switch, RE-SUPPLY Power

Tape Remaining Time

DISPLAY REMAINING TIME

1 Press DISPLAY until the time remaining on the tape appears.

●By pressing the DISPLAY button, you can change the display to show the counter reading, tape remaining time, or clock time.

NOTE:

Depending on the type of tape used, there may be times when the tape remaining time reading may not appear right away, or is not correct. "- - : - -" may sometimes appear, or the display may blink on occasion.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press C.
	MEMORY, and “M” appears in front of the counter digits.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C.MEMORY again.

EN13

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

1	REMOVE POWER SUPPLY
	Unplug the mains power cord from the mains outlet.
2	SET A/B CODE SWITCH
	Set to B.
3	RE-SUPPLY POWER
	Plug the mains power cord back into the mains outlet.
4	TURN THE RECORDER ON
	Press OPERATE on the remote control. The recorder
	will now only respond to B code signals.

NOTE:

Some TV sets may malfunction in response to the B mode. If this happens, switch back to the A mode.

Soundtrack Selection

Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.

During Playback

Pressing AUDIO MONITOR on the remote control changes the soundtrack being played back as follows:

TRACK					USE
Recorder's Front Panel	On-Screen Display
L + R			HI FI		For Hi-Fi stereo tapes
	L			R
L	L		HI FI		For main audio of Bilingual tapes
R			HI FI		For sub audio of Bilingual tapes
				R
NORM		NORM			For audio-dubbed tapes
L + R + NORM			HI FI		For audio-dubbed tapes
		NORM

NOTES:

●"L + R" should normally be selected. In this mode, Hi-Fi stereo tapes are played back in stereo, and the NORM track is played back automatically for tapes with only normal audio.

●For instructions on recording stereo and bilingual programmes, refer to page 18.

●"O.S.D." must be set to "ON" or the on-screen displays will not appear (☞ pg. 17).