JVC HR-J638E/EH Connecting Using A Decoder, INSTALLINGYOURNEWRECORDER cont, TV Receiver

4EN

INSTALLINGYOURNEWRECORDER (cont.)

3

4

SET TV CHANNEL

Set your TV to the video channel (UHF channel 36). Two white bars appear on screen vertically.

●Tune the TV until the bars are as clear as they can be.

●Your TV should be set to the channel designated for use with a video recorder, or to a spare channel if there is not a specified video channel on your TV.

RESET OUTPUT MODE

Return the RF TEST switch to OFF.

Connecting/

Using A

Decoder

TV Receiver
	TV Aerial
RF Cable	Cable
(provided)
AV2 IN/DECODER

AV2 SELECT switch AV1 IN/OUT Rear View

Satellite antenna

NOTES:

●If CH36 is occupied by a local station, adjust the RF output channel adjustment screw to use another channel between CH32 and CH40 instead.

●If some interference noise is continually seen on the screen, consult your JVC dealer.

The AV2 IN/DECODER connector can be used as an input terminal for an external decoder (descrambler). Simply connect a decoder and you can enjoy the variety of programming that is available through scrambled channels.

1	SELECT INPUT MODE
	Set the AV2 SELECT switch to "DECODER".
2	CONNECT DECODER
	Connect your recorder's AV2 IN/DECODER connector
	to the decoder's Euroconnector using a 21-pin SCART
	cable.
3	SET TUNER
	Follow the procedure starting on page 5.

NOTE:

When Connecting A Satellite Tuner . . .

. . . if you don't have a decoder connect the satellite tuner directly to the video recorder's AV2 IN/DECODER connector.

. . . if you have a decoder, first connect the decoder to the decoder input of the satellite tuner, then connect the satellite tuner's output to the recorder's AV2 IN/DECODER connector. Refer to the instruction book for the satellite tuner and decoder.

. . . set the AV2 SELECT switch to "AV2".

. . . to view a programme via the satellite tuner, select AU 2 mode by pressing TV PROG. until "AU 2" appears on the display panel.

Satellite tuner

Decoder