![](/images/new-backgrounds/1280803/28080393x1.webp)
E
N
47
Automatic Sat- ellite Program Recording
This facility allows you to automatically record a satellite program which is
* If you have connected the satellite receiver to the VCR's
S VIDEO IN connector, set "REAR AUX INPUT" to
Before performing the following steps:
Program the timer on the satellite receiver.
Insert a cassette with the safety tab in place.
JOG
SHATTLE
RECLINK | SP/EP |
|
7 8 9
0 4
1
2
SET TAPE SPEED
Press SP/EP to set the tape speed.
ENGAGE AUTO SATELLITE PROG REC MODE
Press and hold REC LINK for about 2 seconds. The button lights up and the VCR turns off automatically.
To disengage the Auto Satellite Prog Rec mode, press REC LINK. The button's light goes off.
If the VCR's power is off, it is not possible to engage the Auto Satellite Prog Rec mode.
1
SP/EP
NOTES:
ATTENTION
Be sure not to turn on the satellite receiver before the program is executed; otherwise, the VCR will start recording when the satellite receiver's power is turned on. If you have connected another appliance other than a satellite receiver to the rear AUDIO/VIDEO IN or S VIDEO IN
Auto Satellite Prog recording and
Auto Satellite Prog recording is only possible with the rear AUDIO/VIDEO IN or
When the Auto Satellite Prog Rec mode is engaged or the VCR's power is turned off after Auto Satellite Prog recording is finished, the VCR will not enter the Timer mode even though "AUTO TIMER" is set to "ON".
For timer programming of the satellite receiver, refer to the instruction manual of the satellite receiver. Auto Satellite Prog recording is not possible if your satellite receiver does not have a timer.
The REC LINK button's light blinks while Auto Satellite Prog recording is in progress.
Pressing the VCR's POWER button while Auto Satellite Prog recording is in progress turns off the VCR's power and disengages the Auto Satellite Prog Rec mode.
If there is more than one satellite program you wish to record with Auto Satellite Prog Recording, it is not possible to set a different tape speed for each; the tape speed selected in step 1 will apply to all the programs for Auto Satellite Prog recording.
The Active Video Calibration ( pg. 32) does not work while Auto Satellite Prog recording is in progress. Auto Clock ( pg. 12) does not work when the Auto Satellite Prog Rec mode is engaged.
Depending on the type of satellite receiver, the VCR may not record a short portion at the beginning of the program or may record slightly longer than the actual length of the program.
If you engage the Auto Satellite Prog Rec mode when the satellite receiver's power is on, the VCR will not start Auto Satellite Prog recording even though the REC LINK button's light blinks. When the satellite receiver shuts off once and is turned back on again, the VCR starts recording.
You can also record a program from your cable system in the same way if the system has a timer and is connected to the VCR's rear AUDIO/VIDEO IN or S VIDEO IN
When you press the VCR's REC LINK button to engage the Auto Satellite Prog Rec mode, if the REC LINK button does not light but instead blinks quickly even though your satellite receiver's power is off, Auto Satellite Prog Recording will not work properly with that satellite receiver*.
If this is the case, perform "Express Timer Programming" ( pg. 42) to
* Some satellite receivers output signals even if the power is off. Auto Satellite Prog Recording is not possible with those satellite receivers.