JVC HR-S4600U instruction manual Start Editing, END Insert Editing

PLAY

JOG

SHATTLE

A.DUB

INSERT

1	2	3
		2
4	5	6
7	8	9
C.RESET	0	4
		PLAY
1
		3

		E	N	53
6	ENGAGE INSERT EDITING
	Press INSERT.
	Your VCR enters the Insert-Pause mode. (" ", " "
	and " " light up on the front display panel.)
	The TV screen changes from the still picture to the
	input source you are going to record.
	START EDITING
	Load the source cassette and play back the segment that
	is to be inserted. When you reach the start of the
7 section of the source tape that you wish to insert, press
	PLAY to start the tape in your VCR; Insert Editing begins
	at this point.

"" and " " are displayed on the front display panel.

END INSERT EDITING

8 At counter "0:00:00", Insert Editing will stop automati- cally and both tapes will continue running in the Play mode. If you wish to stop Insert Editing before the specified edit-out point, press C.RESET.

FOR AV INSERT EDITING

If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time...

In step 6 above, after you press INSERT, press A.DUB also.

("" and "" blink and "" lights up on the display panel.)

NOTES:

Insert editing is not possible with cassettes whose safety tab has been removed.

In insert editing, the recording speed (SP/EP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point.

A small portion of the recording which precedes an insert edit may become erased.

Insert Editing is also possible using the rear connectors. When using these connectors, be sure to select the correct REAR AUX INPUT ("VIDEO" or "S-VIDEO"). To select the correct REAR AUX INPUT, follow steps 4 – 6 from the "Edit From A Camcorder" section, pg 48 and 49.