JVC HR-S4600U Locate Start Point, Engage Audio Dubbing, Start Dubbing, END Audio Dubbing

Audio Dubbing

(HR-S4600U Only)

PAUSE PLAY

JOG

SHATTLE

A.DUB

Audio cable

Audio component

(CD player etc.)

NOTES:

When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks), refer to the "Select The Soundtrack" section ( pg. 27) and select the soundtrack you wish to hear.

Audio dubbing stops automatically when the counter reaches "0:00:00", and the VCR enters the Play mode. Check the counter reading before dubbing.

Audio dubbing is also possible using the rear AUDIO IN connectors.

Audio dubbing cannot be performed on a cassette that has had its record safety tab removed.

When playing back an audio-dubbed tape, refer to the "Select The Soundtrack" section ( pg. 27) to select the soundtrack you wish to hear.

Picture may be distorted during Audio Dubbing Pause. It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.

EN51

Audio dubbing replaces the normal audio sound of a previously recorded tape with a new soundtrack. Use your VCR as the recorder.

Normal audio track

Pre-recorded tape

Video/Hi-Fi audio track

Audio-dubbed tape

	MAKE CONNECTIONS
	Connect an audio component to your VCR's AUDIO IN
	L+ R connectors. *When connecting monaural
1 equipment, use only the VCR's AUDIO IN L connector.
	SET RECORDER’S INPUT
	MODE
	Set to "AUX". Press the NUMBER key “0” and/or CH to
	select depending on the connector being used – "L-1"
2 for the rear AUDIO/VIDEO IN connector, or "F-1" for
	the front AUDIO/VIDEO IN connector.
	LOCATE START POINT
	Press PLAY to start playback of the tape in your VCR,
	and press PAUSE when you find the point where you
3 want to start dubbing.
4	ENGAGE AUDIO DUBBING
	Press A.DUB.
	Your VCR enters the Audio Dubbing Pause mode.
	(" " blinks, " " and " " light up on the front
	display panel.)
	START DUBBING
	Engage the audio component's Play mode, then press
	PLAY to start the tape in your VCR. Audio dubbing
5 begins at this point.

" " blinks and " " is displayed on the front display panel.

To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing.

END AUDIO DUBBING

6 Press STOP to stop the tape in your VCR, and engage the audio component's Stop mode.