JVC HR-XV1EU manual Manual TV station presetting, Example Preset the SAT1 on program position

Manual TV station presetting

ATS stores the broadcast automatically. However if you do the ATS under unfavorable receiving conditions, some broadcasts happen to be not finded by ATS. For these broadcasts, you can store also by manual.

Preparation:

•Turn ON the TV and set to the video input mode.

•Make sure TV/VCR/DVD switch has been slided to VCR/DVD.Then press VCR to select the VCR mode. (The VCR indicator will light)

Example: Preset the SAT1 on program position 5.

1

2

3

Press SET UP MENU.

Press or to select CHANNEL SETUP. Then press

OK.

Press or to select CH TUNING. Then press OK.

DEC OFF will blink. Press OK. DEC OFF does not blink any more. SEARCH will appear.

Note:

If you wish to store the PREMIERE manually, the decoder must have been connected as on the lower of p.11.

ATS (AUTO TUNING SYSTEM)

TIMER REC SET

VCR EXTENSION

VCR SETUP

CHANNEL SETUP

SYSTEM SETUP

SELECT :

ENTER : OK

EXIT : MENU

CHANNEL SETUP

CH TUNING

CHANNEL MAPPING

SELECT :

ENTER : OK

EXIT : MENU

VPS CH 1

ARD

DEC OFF

SELECT :

OK : OK EXIT : MENU

Note:

Occasionally, the auto search might catch a weak signal and stop. If the TV station signal is weak, you shouldn't store this station.

In that case restart the auto search using or .

During DEC OFF is blinking, press DEC ON will blink now.

Press OK.

4 Press (rising frequency) or (falling frequency) once. The search starts. It stops at each broadcast automatically (" " change to " 4 "). Press or repeatedly until the SAT1 appears. Only in case of receiving of the weak broadcast (drifting picture), search dose not stop. If you want to stop, press / or /.

.

		CH 1
DEC OFF
SEARCH :		/ F. TUNE :
EXIT	:	MENU

20