JVC KD-LX555R manual Storing your own sound adjustments, To reset to the factory settings

ENGLISH

Storing your own sound adjustments

You can adjust the sound modes to your preference and store your own adjustments in memory (USER 1, USER 2 and USER 3).

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

1 Press BAND MODE (M).

BAND

MODE“MODE” appears on the

Mdisplay.

2 Press EQ (equalizer) while “MODE” is still on the display.

EQ		The last selected sound mode is
1	7	called up.

3 Select the sound mode you want to adjust.

Ex.: If you have selected “JAZZ”

*By pressing ¢ or 4 , you can directly move as follows:

LOW FREQ. MID FREQ.

HIGH FREQ.

5 Adjust the selected sound element.

• Refer to the table below

for adjusting the selected

sound element.

6 Repeat steps 4 and 5 to adjust the other sound elements.

7 Select one of the user sound modes (USER 1, USER 2, USER 3).

EQ

1 7

8 Press EQ to store the adjustments.

EQ “MEMORY” appears for a while.

17

4 Select sound elements to adjust.

SEL Each time you press the

Sbutton, the sound elements change as follows:

LOW FREQ.* =LOW WIDTH =LOW LEVEL = MID FREQ.* =MID WIDTH =MID LEVEL = HIGH FREQ.* =HIGH LEVEL =

(back to the beginning)

FREQ. (LOW, MID, HIGH):

Select the center frequency to adjust. WIDTH (LOW, MID):

Select the band width level (Q).

LEVEL (LOW, MID, HIGH):

Adjust the enhancement level.

To reset to the factory settings

Repeat the same procedure and reassign the preset values listed in the table on page 49.

Indication	Preset values
	LOW	MID		HIGH
FREQ.	50 Hz	700 Hz	8 kHz
	80 Hz	1 kHz	12 kHz
	120 Hz	2 kHz
WIDTH	1 (min.)	1 (min.)
	4 (max.)	2 (max.)
	–06 (min.)	–06 (min.)	–06 (min.)
LEVEL
	+06 (max.)	+06 (max.)	+06 (max.)

30