JVC KD-LX555R Tuning in to a preset station, Manual preset, Select the band in this example, FM1

Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.

Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band

1 Select the band (in this example, FM1).

Tuning in to a preset station

You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 10 and 11.

1 Select the band.

ENGLISH

ATT

1 Press SOURCE ATT to

ATT

SOURCE

BAND

MODE

M

1Press SOURCE ATT to select FM as the source.

2Press and hold BAND MODE (M) repeatedly to select the FM1 band.

SOURCE

BAND MODE

M

select FM or AM as the

source.

2 If necessary, press and

hold BAND MODE (M) to

select the FM band

number (FM1, FM2 or

2 Tune in to a station (in this example, of 88.3 MHz).

Press ¢to tune in to stations of higher frequencies.

Press 4 to tune in to stations of lower frequencies.

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

EQ

1 7

“PI” flashes for a few seconds.*

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

FM3).

Each time you press and hold the button, the FM band changes as follows:

FM1 FM2 FM3

2 Select the number (1 – 6) for the preset station you want.

EQ	MONO		INT	RPT	RND
1 7	2 8	3 9	10	5 11	612

If the sound quality decreases and the stereo effect is lost while listening to an FM station

In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.

If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity—IF FILTER” on page 34.

11