JVC KD-LX555R Assigning names to the sources, To erase the entered characters, Select a character

Assigning names to the sources

You can assign names to CDs and the external component. After assigning a name, it will appear on the display when you select the source.

Sources	Maximum number of
	the characters
CDs* and	Up to 32 characters (up
CD changer*	to 40 discs)
External component	Up to 10 characters

*You cannot assign a name to a CD Text and an MP3 disc.

1 Select a source you want to assign a name to.

ATT

SOURCE

2 Press and hold SEL (S) for more than 2 seconds while pressing DISP (D).

DISP	SEL
D	S

Ex.: When you select the CD as the source.

3 Select the character set you want while “” is flashing.

DISP Each time you press the button,

Dthe character set changes as follows:

Capital letter () Small letter () Numbers and symbols ()

4 Select a character.

• See “Available characters” on page 37.

5 Move the cursor to the next (or previous) character position.

6 Repeat steps 3 to 5 until you finish entering the name.

7 Press the button while the last selected character is flashing.

SEL	The input name is stored in
S	memory.

ENGLISH

Ex.: When you select the external component as the source.

To erase the entered characters

Insert spaces using the same procedure described above.

Notes:

•When you try to assign a name to the 41st disc, “NAME FULL” appears on the display. (In this case, delete unwanted names before assignment.)

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

35