Assigning names to the sources
You can assign names to CDs and the external components.
After assigning a name, it will appear on the display when you select the source.
Sources | Maximum number of |
| the characters |
CDs * | up to 32 characters |
| (up to 40 discs) |
External components | up to 10 characters |
|
|
*You cannot assign a name to a CD Text.
1 Select a source you want to assign a name to.
When you select a source, the power automatically comes on.
Each time you press the button, the source changes as described on page 7.
2 Press and hold SEL (select) for more than 2 seconds while pressing D (display).
3 Select the character set you want while “ 
” is flashing.
Each time you press the button, the character set changes as follows:
Capital letters ( 
) 
Small letters ( 
)
Numbers and symbols ( 
) 
4 Select a character.
About the available characters, see page 38.
5 Move the cursor to the next
(or previous) character position.
6 Repeat steps 3 to 5 until you finish inputting the name.
7 Finish the procedure while the last selected character is flashing.
ENGLISH
Ex.: When you select “CD PLAY” as the source
To erase the input characters
Insert spaces using the same procedure described above.
Notes:
• When you try to assign a name to the 41st disc, “NAME FULL” appears on the display. (In this case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.
27
