EXTERNAL COMPONENT OPERATIONS
Playing an external component Using a subwoofer
When connecting an external component to the LINE IN plugs on the rear, you can select the component as the sound source.
1 Select the external component (EXT– LINE IN).
Each time you press the button, the source changes as described on page 6.
2 Operate the external component.
Note:
For the external component connection, see the
Installation/Connection Manual (separate volume.)
By connecting a subwoofer to the SUBWOOFER OUT plugs on the rear, you can enjoy enhanced bass sounds and a more realistic theater atmosphere in your car.
•Refer also to the instructions supplied with your subwoofer.
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to “MID”.
To set the subwoofer cutoff frequency, follow the procedure below.
•See also “Changing the general settings (PSM)” on page 21.
•LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.
•MID: Frequencies higher than 80 Hz are cut off to the subwoofer.
•HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.
1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
2 Press ¢ or 4 repeatedly until “CUTOFF F” (frequency) appears on the display.
3Press + or – to select the desired cutoff frequency.
4Press SEL (select) again to finish the setting.
To adjust the subwoofer output volume, see
“Adjusting the sound” on page 18.
ENGLISH
29