ENGLISH
3 Tune into a station you want while “MANU” is flashing.
Press 
¢ to tune into stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
•If you release your finger from the button, the manual mode will automatically turn off after 5 seconds.
•If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9 kHz intervals for AM – MW/LW) until you release the button.
When an FM stereo broadcast is hard to receive:
1Press MODE ATT while listening to an FM stereo broadcast (the STEREO indicator lights up while receiving an FM stereo broadcast).
2Press MO/ 
, while “MODE” is still on the display, so that the MONO indicator lights up on the display.
The sound you hear becomes monaural but the reception will be improved (the STEREO indicator goes off).
Each time you press the button, the MONO indicator lights up and goes off alternately.
Storing stations in memory
You can use one of the following two methods to store broadcasting stations in memory.
•Automatic preset of FM stations: SSM (Strong- station Sequential Memory)
•Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band (FM1, FM2 and FM3.)
1 Select the FM band
1 Press SOURCE (BAND) to select FM as the source.
2If necessary, press and hold SOURCE (BAND) repeatedly to select the FM band (FM1, FM2 or FM3.)
Each time you press and hold the button, the FM band changes as follows:
FM1 
FM2 
FM3
2 Press and hold both buttons for more than 2 seconds.
“SSM” appears, then disappears when automatic preset is over.
Local FM stations with the strongest signals are searched and stored automatically in the band number you have selected (FM1, FM2 or FM3.) These stations are preset in the number buttons — No.1 (lowest frequency) to No.6 (highest frequency.) When automatic preset is over, the station stored in number button 1 will be automatically tuned in.
8
