JVC KY-F58 instruction manual Camera Control Rear side Cont’d

2. CONTROLS, INDICATIONS AND CONNECTORS (Cont’d)

CAMERA CONTROL [Rear side] (Cont’d)

		25		24	23	22	21	20
AC- INPUT	SEE INSTRUCTION MANUAL	RS-232C		EXT REF				OUTPUT
				VD	HD/VBS	VIDEO		Y/C
		LENS		EXT TRIGGER
		REMOTE	FLASH	WEN	FREEZE			RGB/COMPONENT
	SIGNAL
	EARTH
26	27	28	29	30	31

20[Y/C] Y/C output signal connector (4 Pin)

This connector outputs Y/C separated video signal.

25 [RS-232C] Communication port (D-Sub 9Pin)

Connect to an RS-232C interface in a personal computer

43

21

View from the rear of the KY-F58

(4-pin connector, female)

Pin No. Signal

1GND (ground)

2 GND (ground)

3 Luminance (Y, 1 V(p-p), 75-ohm)

4 Chroma signal

(C, 0.286 V (p-p), 75-ohm) [U Ver.] (C, 0.3 V (p-p),75-ohm) [E Ver.]

or other control unit.
Use a cross cable for connection.
1	5

View from the rear of the KY-F58 (9-pin connector, male)

6		9
Pin No.	Detail	Pin No.	Detail
1	NC	6	DSR

21[RGB/COMPONENT] RGB/Component output connector (9Pin)

This is the RGB/Component signal output connector.

To switch between the RGB and the COMPONENT on the MENU screen.

Refer to the “TOTAL SETTING SCREEN” on page 25.

51

View from the rear of the KY-F58

			(9-pin connector, female)
9		6
Pin No.	Signal		Pin No.	Signal
1	GND		6	VBS
2	GND		7	SYNC
3	R/R-Y		8	GND
4	G/Y		9	GND
5	B/B-Y

2	RxD	7	RTS
3	TxD	8	CTS
4	DTR	9	NC
5	GND

26[AC INPUT] AC Power connector

It connects with a provided AC cable to a standard AC120V electric outlet.

[SIGNAL EARTH] signal ground terminal

This is not a ground for safety from electrical shock. It is a GND for signals among units.

[LENS REMOTE] lens remote control connector

It connects to the lens remote control unit (optional). Refer to the “SYSTEM APPLICATION” on page 11.

91

82

10

22[VIDEO] Video output connector (BNC)

This is the composite video signal output connector.

23[HD/VBS] HD/VBS sync signal input connector (BNC) This connector inputs HD (Horizontal sync signal) or VBS (Composite video signal) to synchronize the unit.

Refer to the “SYSTEM APPLICATION” on page 11.

24[VD] VD sync signal input connector (BNC)

This connector inputs VD (vertical sync signal) to synchro- nize the unit.,

7	12	11	3
6		4	View from the rear of the KY-F58
			(12-pin connector, female)
		5
Pin No.		Signal		Pin No.	Signal
1	SERVO SELECT(F)			7	COM
2	SERVO SELECT(Z)			8	FOCUS CTL
3		GND		9	ZOOM CTL
4		IRIS C/L		10	SERVO SELECT(I)
5		IRIS CTL		11	COM (+V)
6		12V		12	COM (–V)

Revised in August 1998 7