3. CONNECTIONS
BASIC SYSTEMS
Mounting the optional lens (T14 X 5.5MD) to the camera head (See page 9.)
Lens | male | Monitor | |
(T14 x 5.5 MD) | Camera head | female | |
To CCU | |||
|
| ||
|
| ||
| COLOR VIDEO CAMERA |
| |
| To LENS |
|
How to mount the camera head (See page 10.)
Connecting the camera
[LENS REMOTE]head and CCU (See page 10.)
Provided cable |
|
(5m) | OUTPUT |
|
Recommended Remote Controllers
•
Note:
When using an extension cable, the screen flickers slightly during the focusing operation..
• RMD-10 (FUJINON) for speed control
male
To CAMERA
| CAMERA CONTROL UNIT | LENS REMOTE terminal | ||
PULL OPENMENU | FILES | FREEZE | ||
1 | 2 | 3 | 4 | on the rear panel |
SELECT |
|
| MEMORY | |
|
|
| POWER |
|
TO CAMERA | WHITE PAINT | VIDEO LEVEL |
SET | FULL AUTO | LEVEL |
|
| ON |
RB
OFF
PAINT
CCU (Camera Control Unit) | LENS remote control |
female
• The LENS remote controller should be connected to the REMOTE terminal on the rear panel of the CCU or to LENS REMOTE on the lens.
MOUNTING THE OPTIONAL LENS (T14 X 5.5MD) TO THE CAMERA HEAD
Camera head 3.
Screws
Mount fastening ring
Lens
2.
1. Remove the lens mount cap for the camera.
Be careful no dust gets into the mounting hole when you remove it.
2. Attach the screw of the camera head mount section to that of the lens mount section. Turn the mount fastening ring slowly clockwise and fix the lens to the camera head by screwing it firmly.
To change the attitude angle of the lens rotating direction.
1Turn the mount fastening ring
2Turn the lens slowly to adjust the attitude angle, and fas- ten it again firmly with the mount fastening ring.
Note:
The |
|
| 4mm or less | 3. Plug in the lens cable to the LENS connector of the camera | |||||
When a lens other than the T14x5.5MD |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| ||
of the |
|
|
|
|
|
|
|
| head and fasten it firmly. |
|
|
|
|
|
|
|
|
| |
cause the | Lens |
|
|
|
|
|
| For more details, refer to the Instructions for the Lens. | |
such a lens is used, the lens' height |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
should not be more than 4 mm above the |
|
|
|
|
|
|
|
|
|
lens mount surface. |
|
|
|
|
|
|
|
|
|
9
