JVC LET0070-002A manual Connecting an External Component, Main Unit, Right speaker, Left speaker

CAUTION: Make all connections before plugging the unit into an AC power outlet.

Connecting the Speakers (Refer to instructions for speakers as well.)

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the CA-MD9R and the other end to the speaker.

1.Open the terminals and insert the speaker wires firmly (be sure to remove the insulation at the ends of each wire first), then close the terminals.

2.Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the CA-MD9R.

Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–) terminals marked LEFT on the CA-MD9R.

Right speaker

Main Unit

SPEAKERS

RIGHT LEFT

Left speaker

IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on the back panel.

CAUTION: If a TV is installed near the speakers, the picture on the TV may be distorted. If this happens, place the speakers away from the TV.

Connecting an External Component

You can connect another component to the AUX jacks, and reproduce the sound of the component through the CA-MD9R.

To the audio output jacks

AUX

VCR (or another component) LEFT

RIGHT

Note: When you connect a VCR to the CA-MD9R, connect the VCR and the TV directly using the video cords to watch a video tape or record a TV program.

5