JVC LVT1002-012B manual Troubleshooting, General, Problem Possible Cause Solution

Troubleshooting

Use this chart to help you solve daily operational problems. If there are any problems you cannot solve, contact your JVC’s service center.

RX-ES1SL

General

PROBLEM	POSSIBLE CAUSE	SOLUTION
The power does not come on.	The power cord is not plugged in.	Plug the power cord into an AC outlet.
No sound from speakers.	Speaker signal cables are not connected.	Check speaker wiring and reconnect if necessary.
	An incorrect source is selected.	Select the correct source.
	Muting is activated.	Press MUTING to cancel the mute.
	An incorrect input mode (analog or digital)	Select the correct input mode (analog or digital).
	is selected.
	Connections are incorrect.	Check connections.
Sound from one speaker only.	The balance is set to one extreme.	Adjust the balance properly (see page 23).
The unit turns off and becomes standby	Speakers are overloaded because of high	1. Stop the playback source.
mode.	volume.	2. Turn on the unit again, and adjust the volume.
	Speakers are overloaded because of a	Check the speaker wiring.
	short circuit at the speaker terminals.	If speaker wiring is not short-circuited, contact your
		dealer.
	The unit is overloaded because of a high	Consult your dealer after unplugging the power cord.
	voltage.
Remote control does not operate as	The remote control is not ready for your	Press a source selecting button or TONE first, then
you intend.	intended operation.	press the buttons you want to use. (See pages 22
		and 67 – 69.)
Remote control does not work.	There is an obstruction hiding the remote	Remove the obstruction.
	sensor on the unit.
	Batteries are weak.	Replace batteries.
	The mode selector is set to the incorrect	Set the mode selector to the proper position.
	position.
Bass sound is reinforced too much	Appropriate bass level is not selected.	Adjust audio position level (see page 23).
when listening in stereo.

70