English
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.
Before Installation
General Precautions
•Be sure your hands are dry.
•Turn the power off to all components.
•Read the manuals supplied with the components you are going to connect.
Locations
•Install the receiver in a location that is level and protected from moisture.
•The temperature around the receiver must be between
•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
Handling the receiver
•Do not insert any metal object into the receiver.
•Do not disassemble the receiver or remove screws, covers, or cabinet.
•Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the receiver.
The number in the parentheses indicates quantity of the pieces supplied.
•Remote Control (1)
•Batteries (2)
•AM Loop Antenna (1)
•FM Antenna (1)
•AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Adjusting the Voltage Selector
Before connections, always do the following first if necessary.
Select the correct voltage with the VOLTAGE SELECTOR switch on the rear using a screw driver.
Check to be sure if the voltage mark is set to the voltage for the area where you use this unit.
220V 
110V
127V
VOLTAGE SELECTOR
PBPR
+CAUTION : SPEAKER IMPEDANCE
|
| 1 | OR 2 | : 8 | 16 |
+ | + | 1 AND 2 : 16 | 32 | ||
220V |
| 110V | |||
|
|
| |||
– | – |
|
|
| 127V |
– |
|
|
|
| |
RIGHT | LEFT |
|
|
|
|
| RIGHT | LEFT | |
CENTER | 1 | 2 | |
SPEAKER |
| FRONT SPEAKERS |
|
VOLTAGE SELECTOR
Voltage mark
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries
first. |
|
|
1 | 2 | 3 |
|
| |
| AA(15F) |
|
1.Press and slide the battery cover on the back of the remote control.
2.Insert the batteries.
• Make sure to match the polarity: (+) to (+) and
3.Replace the cover.
If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two
Notes:
•Supplied batteries are for the initial setup. Replace the batteries for continued use.
•After replacing the batteries, set the manufacturers’ codes again (see pages 45 to 48).
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity:
(+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
7
