JVC RX-1024VBK manual Connecting the rear and center speakers, Connecting the subwoofer speaker

Getting Started

Connecting the rear and center speakers

Connect the rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

CAUTION:

Use speakers with the

Center speaker

Left rear speaker

RIGHT LEFT

+

+

Right rear speaker

–

CENTER	REAR	–
SPEAKER	SPEAKERS

SPEAKER IMPEDANCE indicated by the speaker terminals.

Note:

To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:

Connecting the subwoofer speaker

Connect the input jack of a powered subwoofer to the SUBWOOFER jack on the rear panel, using a cable with RCA pin plugs.

PRE OUT

REAR

SUB

LEFT WOOFER

FRONT

LEFT

Powered subwoofer RIGHT CENTER RIGHT

To enhance your audio system

You can use this receiver as the pre-amplifier (control amplifier) when you connect power amplifiers to the PRE OUT jacks on the rear panel, using cables with RCA pin plugs.

PRE OUT
Example: When using a stereo power amplifier
REAR
for connecting the rear speakers	SUB
LEFT	WOOFER
	FRONT
	LEFT
Power amplifier
RIGHT	CENTER RIGHT

Left rear speaker Right rear speaker

•Set it to the HIGH position when the impedance of the speakers connected is within the range of 8 ohms to 16 ohms.

•Set it to the LOW position when the impedance of the speakers connected is within the range of 4 ohms to 6 ohms.

•Set it to the LOW position when the impedance of the any speaker connected is 6 ohms or less.

7