JVC RX-1024VBK manual Press Test again to stop the test tone, To cancel the Theater Surround mode

5. Adjust the speaker output levels as follows:		–	CNTR	+
	2			3		MENU
• To adjust the center speaker level, press CNTR +/–.
• To adjust the left rear speaker level, press REAR•L +/–.
• To adjust the right rear speaker level, press REAR•R +/–.	REAR · L		+	–	REAR · R +
–
5		ENTER	6	8	9

6. Press TEST again to stop the test tone.	TEST
	4

7. Press CNTR TONE to select the center tone level you want.	CNTR TONE
The center tone adjustment affects the mid-frequency	1
range, which the human voice is mostly made up of.
Each time you press the button, the display changes to
show the following:

SOFT2 SOFT1 FLAT SHARP1 SHARP2

Adjusted levels are also shown on the equalizer display.

This CNTR means this adjustment can be applied to the center speaker only.

S E A CNTR (Example: When “FLAT” is selected.)

Notes:

•You can adjust the speaker output levels and center tone without outputting the test tone.

•You cannot adjust the center speaker level when “CENTER SPK” is set to “NONE” (see page 19).

•You cannot adjust the rear speaker levels when “REAR SPK” is set to “NONE” (see page 19).

Note:

The center tone cannot be adjusted when “CENTER SPK” is set to “NONE” (see page 19).

100 1k 10k

To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much). To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much). When “FLAT” is selected, no adjustment is applied.

8. Press EFFECT to select the effect level.				EFFECT
Each time you press the button, the effect level changes				7/P
as follows:
DSP EFFECT 1	DSP EFFECT 2		DSP EFFECT 3
DSP EFFECT 5		DSP EFFECT 4

As the number increases, the surround effect becomes stronger.

To cancel the Theater Surround mode

Press SURROUND MODE repeatedly until “OFF” appears.

The DSP and THEATER indicators goes off.

Note:

You cannot adjust the effect level when “REAR SPK” is set to “NONE” (see page 19).

38