AM (MW) Antenna Connections
Turn the loop until you have the best reception.
Basic connecting procedure
1 Twist and remove the insulation at the end of each speaker signal cable (not supplied).
2 Open the speaker terminal.
ANTENNA
AM
EXT
FM 75
COAXIAL
AM
LOOP
AM (MW) Loop Antenna (supplied)
Snap the tabs on the loop into the slots of the base to assemble the AM (MW) loop.
+ –
LEFT
RIGHT
For FRONT SPEAKERS 2 terminals
3 Insert the speaker signal cable.
1 | 2 | 3 |
Outdoor single
Notes:
•If the AM (MW) loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
•If reception is poor, connect an outdoor single
Connecting the Speakers
You can connect the following speakers:
•Two pairs of front speakers to produce normal stereo sound.
•One pair of surround speakers to enjoy the surround effect.
•One surround back speaker or one pair of surround back speakers to enjoy to produce more effective surround effect.
•One center speaker to emphasize human voices.
•One subwoofer to enhance the bass.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.
•When connecting to both of the FRONT SPEAKERS 1 and 2 terminals, use speakers with an impedance of 16 Ω to 32 Ω.
•When connecting to either the FRONT SPEAKERS 1 or 2 terminals, use speakers with an impedance of 8 Ω to 16 Ω.
+ –
LEFT
RIGHT
4 Close the speaker terminal.
+ –
LEFT
RIGHT
For each speaker (except for a subwoofer), connect the (+) and
Speaker layout
Ideal speaker layout varies depending on the conditions of your listening room. The diagram below is a recommended typical example.
Subwoofer
Left front speaker(s) Center speaker | Right front speaker(s) | |
(L) | (C) | (R) |
Left surround | Right surround |
speaker (LS) | speaker (RS) |
Surround back speakers (LSB/RSB)
8