Turning Analog Direct On and Off
You can enjoy the sound closer to the original source by overriding the sound adjustments such as speaker output level adjustments (see page 30), Digital Equalization (see page 30), Surround and DSP modes (see pages 32 to 37), Bass Boost (see page 19) and Midnight Mode (see page 17). You can only adjust the volume level while Analog Direct is in use.
•Once you have made adjustment, it is memorized for each analog source.
Changing the Source Name | Remote |
NOT |
When you have connected an CD recorder to the TAPE/CDR IN jacks or a DBS tuner to the TV SOUND/DBS IN jacks on the rear panel, change the source name which will be shown on the display.
ANALOG DIRECT
Press ANALOG DIRECT so that “A DIRECT” appears on the display.
ANALOG
L C | R LINEAR PCM |
SUBWFR | SPEAKERS 1 |
LS | RS |
VOLUME
The lamp on the button also lights up.
• Each time you press the button, Analog Direct turns on and off.
Notes:
•When digital input mode is in use, Analog Direct is not available.
•Turning on Surround or DSP mode cancels Analog Direct and previously selected sound adjustments are recalled.
•If Analog Direct is in use, Midnight Mode is temporarily canceled.
•Turning on Analog Direct cancels Input Attenuator (page 17).
When changing the source name from “TV” to “DBS”:
1.Press TV SOUND/DBS.
• Make sure “TV” appears on the display.
2.Press and hold TV SOUND/DBS until “ASSGN DBS” appears on the display.
| ANALOG |
|
L | R | LINEAR PCM |
SUBWFR | SPEAKERS 1 | |
VOLUME
Note:
When connecting a DBS tuner to the TV SOUND/DBS IN jacks, change the source name to “DBS,” which will be shown on the display when selected as the source. Otherwise you cannot view any picture from DBS tuner.
When changing the source name from “TAPE” to “CDR”:
1.Press TAPE/CDR.
• Make sure “TAPE” appears on the display.
2.Press and hold TAPE/CDR until “ASSGN CDR” appears on the display.
| ANALOG |
|
L | R | LINEAR PCM |
SUBWFR | SPEAKERS 1 | |
VOLUME
To change the source name to “TV” and “TAPE,” repeat the
same procedure above.
Note:
Without changing the source name, you can still use the connected components. However, there may be some inconvenience.
–“TAPE” or “TV” will appear on the display when you select the CD recorder or DBS tuner.
–You cannot use the digital input (see page 18) for the CD recorder.
18
