Operating JVC’s Audio/Video Components
You can operate JVC’s audio and video components with this receiver’s remote control, since control signals for JVC’s components are preset in the remote control.
Operating Audio Components
IMPORTANT:
To operate JVC’s audio components using the supplied remote control:
•You need to connect JVC’s audio components through the COMPU LINK (SYNCHRO) jacks (see page 39) in addition to the connections using cables with RCA pin plugs (see pages 10 to 12).
•Aim the remote control directly at the remote sensor on the receiver.
•If you use the buttons on the front panel to choose a source, the remote control will not operate that source. To operate a source with the remote control, the source must be selected using source selection buttons on the remote control.
•To operate the target component using the COMPU LINK remote control system, set the source name correctly if required. (See page 18.)
•Refer also to the manuals supplied with your components.
Tuner
You can always perform the following operations:
FM/AM: Alternate between FM and AM (MW).
After pressing FM/AM, you can perform the following operations on a tuner:
1 – 10/0, +10: Select a preset channel number directly. For channel number 5, press 5.
For channel number 15, press +10, then 5. For channel number 20, press +10, then 10/0.
PTY SEARCH: Searches for a program by PTY codes.
PTY9/(PTY: Selects the PTY codes.
DISPLAY MODE: Shows the RDS signals.
TA/NEWS/INFO: Select the Enhanced Other Networks data type (TA, NEWS, INFO)
FM MODE: Changes the FM reception mode.
Sound control section (Amplifier)
You can always perform the following operations:
SURROUND: | Turn on and select Surround modes |
DSP: | Turn on and select DSP modes. |
SURR/DSP OFF: | Turn off Surround and DSP modes. |
After pressing SOUND, you can perform the following operations:
FRONT•L then LEVEL
FRONT•R then LEVEL
level.
CENTER then LEVEL
SURR•L then LEVEL
SURR•R then LEVEL
SURR BACK then LEVEL
Adjust the surround back speaker output level.
SUBWOOFER then LEVEL
Adjust the subwoofer output level.
DIGITAL EQ then
| and adjust its level. |
TEST: | Turn on or off test tone output. |
BASS BOOST: | Turn on or off Bass Boost. |
Note:
After adjusting sounds, press the corresponding source selection button to operate your target source by using the 10 keys; otherwise, the 10 keys cannot be used for operating your target source.
40
