JVC RX-772VBK manual Connecting Audio/Video Components, Audio component connections

Connecting Audio/Video Components

You can connect the following audio/video components to this receiver using cables with RCA pin plugs (not supplied). Refer also to the manuals supplied with your components. If you want to connect a component not listed in the table below, refer to the manual supplied with it.

Audio Components		Video Components
•	Turntable	•	TV
•	CD player	•	VCR
•	Cassette deck	•	Video disc player

Note:

•If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

•Any turntables incorporating a small-output cartridge such as an MC (moving-coil type) must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

Audio component connections

GND

CD player

To audio output

If an earth cable is provided for your turntable, connect the cable to the screw marked GND on the rear panel.

To audio output

AUDIO

RIGHT LEFT

PHONO
CD
OUT	OUT
(REC)	(REC)
VCR	VCR
IN	IN
(PLAY)
	(PLAY)

Turntable

VIDEO VIDEO

Cassette deck

To audio input

To audio output

TV

SOUND MONITOR OUT

OUT

(REC)

TAPE

IN

(PLAY)

VIDEO

If your audio components have a COMPU LINK-3 terminal

The COMPU LINK remote control system allows you to control other JVC audio components from the receiver or vice versa.

Connect your audio components and the receiver with the cable (monaural mini-plug supplied with those components) as well as the connection above.

For detailed information about the connection and the COMPU LINK-3 remote control system, see page 35.

Note:

The COMPU LINK-3 remote control system is the upgraded version of the COMPU LINK-1 and COMPU LINK-2. Even if your component has the COMPU LINK-1 or COMPU LINK-2 jacks, you can still connect it in the COMPU LINK-3 remote control system, but some functions may not work correctly.

Page 8