Front panel
6.Press Control %/ Þuntil
7.Press Control @/ #to adjust the delay time of the rear speaker output. Each time you press the button, the delay time changes as follows:
DELAY 1 |
| DELAY 2 |
| ||
DELAY 4 |
| DELAY 3 |
|
DELAY 1: | Select this when the distance from you to your rear speakers is greater than that to the front |
| speakers. |
|
|
DELAY 2: | Select this when the distance from you to your rear speakers is almost equal to that to the |
| front speakers. |
|
|
DELAY 3: | Select this when the distance from you to your rear speakers is a little less than that to the |
| front speakers. |
|
|
DELAY 4: | Select this when the distance from you to your rear speakers is much less than that to the |
| front speakers. |
|
|
Note:
When you have selected “3CHLOGIC,” you cannot adjust the delay time.
8. Press Control %/ Þuntil “TEST” appears on the display, then press Control @/ #to start checking the speaker output balance.
“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following order:
| Left front speaker |
|
| Center speaker |
| Right front speaker |
| |
|
|
|
|
| ||||
|
|
| Rear speakers |
|
|
|
| |
|
|
|
|
|
|
|
Notes:
•No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”
•No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center mode.
9.If necessary, adjust the speaker output balance as follows:
•To adjust the rear speaker output level, press Control %/ Þuntil “– REAR +” appears on the display, then press Control @/ #.
•To adjust the center speaker output level, press Control %/ Þ until
Notes:
•You cannot adjust the left and right rear speakers output level separately.
•You cannot adjust the rear speakers output level when you have selected “3CHLOGIC.”
•You cannot adjust the center speaker output level when you select “PHANTOM” or “OFF” for the center mode.
10. Press Control %/ Þuntil “TEST” appears on the display, then press Control @/ #to stop the test tone.
11.Press Control %/ Þ until “CNT TONE” (Center Tone) appears on the display.
12.Press Control @/ #to select the center tone you want.
The center tone adjustment affects the
Each time you press the button, the display changes to show the following:
SOFT2 SOFT1 FLAT SHARP1 SHARP2
To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much).
To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much).
When “FLAT” is selected, no adjustment is applied.
Note:
The center tone cannot be adjusted when sounds do not come out of the center speaker.
Page 28