JVC RX-772VBK manual Adjusting the Volume, Selecting the Front Speakers, On the front panel only

VIDEO VCR TAPE

TVSOUND FM/AM CD PHONO

Remote Control

Adjusting the Volume

MASTER VOLUME

–+

Front panel

VOLUME +

–

Remote Control

From the remote control:

Press one of the source selecting buttons you want.

VIDEO	Play back a video source on the video component connected to the VIDEO jacks.
VCR	Play back a video source on the video component connected to the VCR jacks.
TV SOUND	Listen to TV sounds.
FM/AM*	Listen to the radio.
	Each time you press the button, the band alternates between FM and AM.
TAPE*	Listen to a cassette tape connected to the TAPE jacks.
CD*	Listen to a CD.
PHONO*	Listen to a record.

Note:

When you press one of the source selecting buttons marked above with an asterisk (*), the receiver automatically turns on.

When you change the volume level, the volume level is shown on the display.

On the front panel:

To increase the volume, turn MASTER VOLUME clockwise.

To decrease the volume, turn MASTER VOLUME counterclockwise.

Note:

When you turn MASTER VOLUME rapidly, the volume level also changes rapidly. When you turn MASTER VOLUME slowly, the volume level also changes slowly.

From the remote control:

To increase the volume, press VOLUME +.

To decrease the volume, press VOLUME –.

CAUTION:

Always set the volume level to the minimum before starting any source. If the volume level is left turned up, the sudden blast of sound energy can permanently damage your hearing and/ or ruin your speakers.

Selecting the Front Speakers

SPEAKERS

12

_ON ÑOFF

Front panel

On the front panel only:

When you have connected two pairs of the front speakers, you can select which to use. Pressing SPEAKERS 1 or SPEAKERS 2 to set it in the _ON position activates the respective pair of the speakers.

To use the speakers connected to the FRONT SPEAKERS 1 terminals, press SPEAKERS 1 to set it in

the _ON position, and press SPEAKERS 2 to set it in the ÑOFF position.

To use the speakers connected to the FRONT SPEAKERS 2 terminals, press SPEAKERS 2 to set it in

the _ON position, and press SPEAKERS 1 to set it in the ÑOFF position.

To use both pairs of the speakers, press both SPEAKERS 1 and 2 to set them in the _ON position. To use neither pair of the speakers, press both SPEAKERS 1 and 2 to set them in the ÑOFF position.

Note:

When only one set of the speakers is connected to either the FRONT SPEAKERS 1 or 2 terminals, do not press both SPEAKERS 1 and 2 to set them in the _ON position. If you do, no sound comes out of the front speakers.

Page 12