JVC RX-772VBK manual Connecting the Speakers, Connecting the front speakers

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

For each speaker (except for subwoofer), connect the black (–) and red (+) terminals on the rear panel to the black (–) and red (+) terminals marked on the speakers. For connecting a subwoofer, see page 7.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Connecting the front speakers

Cut, twist and remove the insulation at the end of each speaker signal cable first, and then, connect the front speakers to the FRONT SPEAKERS terminals by using the cables.

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

SPEAKER LOW HIGH LOAD

SELECTOR

FRONT SPEAKERS

	RIGHT		LEFT
1				1	SPEAKER
				SPEAKER
				IMPEDANCE	LOAD
+	–	–	+	/ OHMS	SELECTOR
				4 ~ 6	LOW
				8 ~ 16	HIGH	Left Speaker	Right Speaker

2 2

1 Turn the knob	2 Insert the speaker	3 Turn the knob
counterclockwise.	signal cable.	clockwise.
1	1	1
RIGHT	RIGHT	RIGHT

Notes:

•To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which should be set to match the impedance of the connected speakers.

Set this selector according to the indications by the FRONT SPEAKERS terminals.

•When you connect two pairs of the speakers to the FRONT SPEAKERS terminals, use the speakers having the impedance within the same range.

Page 6