JVC RX-772VBK manual Using the On-Screen Display to Control the Receiver, Basic Procedures

Using the On-Screen Display to Control the Receiver

You can use the menu function on the TV screen to control the receiver.

To use this function, you need to connect the TV to the MONITOR OUT jack on the rear panel (see page 9), and set the TV’s input mode to the appropriate position to which the receiver is connected.

When the TV’s input mode is for TV, you cannot see the on-screen display.

IMPORTANT:

When you use the menu functions, make sure that you have connected a TV and operate the menu function while watching the on-screen displays on the TV.

Basic Procedures

Menu function buttons

			CONTROL
		TAPE		VCR
MENU						MENU
EXIT
O						L
N	S					O
					T
		C		N		R
		R
			EEN CO

MAIN MENU

From the remote control:

1.Press MENU.

The MAIN MENU appears on the TV screen.

•If you press %/ Þ/ @/ #, a sub-menu you can adjust at that time appears on the TV screen instead of the MAIN MENU.

2.Press %/ Þto move to the sub-menu you want to set, then press @/ #. The sub-menu you want appears.

3.If necessary, press % / Þ/ @/ #to set or adjust the item you want on the selected sub- menu.

When a item is selected, the item will be highlighted.

Note:

Moving to an item does not mean that you have selected it. If the item is not highlighted, press @/ #to highlight it.

4.When you finish, press MENU EXIT. The menu disappears from the TV.

To go back to the MAIN MENU any time during the process

Press MENU again.

Shows the buttons you can use on the current menu. In this case, press % / Þ to move up and down, and @ / # to select the item. (The menus are shown on the TV for about one minute.)

Selecting the Source to Play (Also see page 11)

1.Press MENU.

The MAIN MENU appears on the TV.

2. Press %/ Þto move to “SOURCE,” then press @/ #.

The SOURCE menu appears.

3.Press %/ Þ to move to the source you want to play.

4.When you finish, press MENU EXIT. The menu disappears from the TV.

Adjusting the Front Speaker Output Balance (Also see page 14)

1.Press MENU.

The MAIN MENU appears on the TV.

2. Press %/ Þto move to “SETTING,” then press @ / #.

The SETTING menu appears.

3.Press %/ Þto move to “BAL.” (Balance).

4.Press @/ #repeatedly to adjust the balance.

5.When you finish, press MENU EXIT. The menu disappears from the TV.

SOURCE menu

SETTING menu

Shows the buttons you can use on the current menu.

In this case, press % / Þ to

move up and down, and @ / # to adjust or set the item.

Page 31