JVC RX-772VBK Connecting the FM and AM Antennas, FM Antenna Connections, AM Antenna Connections

Connecting the FM and AM Antennas

FM Antenna Connections

123

FM Antenna Extend the FM wire antenna horizontally.

ANTENNA

FM		4	Outside FM Antenna Wire
75
FM
GND
GND	1		2	3 7/16 in.

AM

LOOP

AM
EXT	13/16 in.	(10 mm)
	(20 mm)

If reception is poor, connect the outside antenna. Before attaching a 75-ohm coaxial cable (the kind with a round wire going to an outside antenna), disconnect the supplied FM antenna.

How to strip the 75-ohm coaxial cable and connect it to the FM terminals

1.Strip back the outside covering of the 75-ohm coaxial cable to expose the braided metallic mesh about 13/16 inches (20 mm).

2.Pull the mesh back and twist it into a single connector, as shown in the illustration above.

3.Strip the insulation about 7/16 inches (10 mm) back from the central wire.

4.Insert the twisted mesh and the central wire to the FM terminals, as shown in the illustration above.

AM Antenna Connections
ANTENNA			Turn the loop until you have
			the best reception.
FM
75
FM
GND	AM Loop Antenna
GND
AM
LOOP
AM			Snap the tabs on the loop into the slots of
EXT
1	2	3	the base to assemble the AM loop.

Note:

Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

Outdoor Single Vinyl-covered Wire

If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

Page 5