JVC RX-8012RSL, RX-8010RBK manual Basic Settings, Adjusting the Front Speaker Output Balance

TAPE / MD

SOURCE NAME

Basic Settings

Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier. You can also use on-screen menus for most of the operations mentioned in this section. For details, see page 40.

Adjusting the Front Speaker Output

Balance

If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance.

• You can do this setting for each source.

Before you start, remember....

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

1.	Press LEVEL ADJUST repeatedly			LEVEL
			L
	until “BAL– (with current			ADJUST
	setting)” appears on the display.
2.	Press CONTROL UP 5/DOWN °		CONTROL
		DOWN UP

to adjust the balance.

• Pressing CONTROL UP 5 decreases the left channel output (from CENTER to L–21).

•Pressing CONTROL DOWN °decreases the right channel output (from CENTER to R–21).

From the remote control:

1. Press SOUND. SOUND

The 10 keys are activated for sound adjustments.

Changing the Source Name

When you have connected an MD recorder to the TAPE/MD jacks or the DBS tuner to the TV SOUND/DBS jacks on the rear panel, change the source name which will be shown on the display when you select the MD recorder or DBS tuner as the source.

On the front panel ONLY:

When changing the source name from “TAPE” to “MD”:

• Press and hold SOURCE NAME (TAPE/MD) until “ASSGN. MD” appears on the display.

When changing the source name from “TV” to “DBS”:

• Press and hold SOURCE NAME (TV TV SOUND/DBS

SOUND/DBS) until “ASSGN. DBS”
appears on the display.	SOURCE NAME

To change the source name to “TAPE” or “TV,” repeat the same procedure above — press and hold SOURCE NAME (TAPE/MD) to select “TAPE,” or press and hold SOURCE NAME (TV SOUND/DBS) to select “TV.”

Note:

Without changing the source name, you can still use the connected components. However, there may be some inconvenience.

2. Press L/R BAL.

“L/R” appears on the remote control display window.

3.Press BAL L or BAL R to adjust the balance.

•Pressing BAL L decreases the right channel output (from CENTER to R–21).

•Pressing BAL R decreases the left channel output (from CENTER to L–21).

∗L/R BAL

8

+∗BAL L

CH/∗LEVEL

−∗BAL R

–“TAPE” or “TV” will appear on the display when you select the MD recorder or DBS tuner.

–You cannot use the digital input (see page 19) for the MD recorder.

–You cannot use the COMPU LINK remote control system (see page 45) to operate the MD recorder.

16