PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
“OVERLOAD” starts flashing on the display.
Speakers are overloaded because of high | 1. | Press STANDBY/ON |
| on the front | ||
volume. |
| panel to turn off the receiver. | ||||
| 2. | Stop the playback source. | ||||
| 3. | Turn on the receiver again, and adjust the | ||||
|
| volume. |
|
| ||
|
|
|
|
|
| |
Speakers are overloaded because of short | Press STANDBY/ON |
|
|
| on the front panel, | |
|
| |||||
|
| |||||
circuit of speaker terminals. | then check the speaker wiring. | |||||
| If “OVERLOAD” does not disappear, unplug | |||||
| the AC power cord, then plug it back again. |
If speaker wiring is not
The STANDBY lamp lights up after turning on the power, but soon the receiver turns off again (into standby mode).
The receiver is overloaded because of a high voltage.
Press STANDBY/ON on the front panel to turn off the receiver. After unplugging the AC power cord, consult your dealer.
Remote control does not work.
There is an obstruction in front of the | Remove the obstruction. |
remote sensor on the receiver. |
|
Batteries are weak. | Replace batteries. (See page 10.) |
Remote control does not work intendedly.
An incorrect remote control operation mode is selected.
Select the correct remote control operation mode. (See page 51 – 56.)
58