Low Frequency Effect Attenuator Setting
If the bass sound is distorted while playing back a source using Dolby Digital or DTS Digital Surround, follow the procedure below.
On the front panel ONLY:
1. Press SETTING repeatedly until | CT SETTING |
“LFE ATT” (Low Frequency |
|
Effect Attenuator) appears on the |
|
display. |
|
Digital Input (DIGITAL IN) Terminal Setting
When you use the digital input terminals, you have to register what components are connected to which terminals (DIGITAL IN 1/2/3/4).
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN ° CONTROL
DOWN UP
to select the low frequency effect attenuator level.
• Each time you press the button, the display changes to show the following:
0dB 10dB
0dB: Normally select this.
10dB: Select this when the bass sound is distorted.
Notes:
On the front panel ONLY:
To set the DIGITAL 1 terminal:
1.Press SETTING repeatedly until “DGTL COAX” (Digital Coaxial)
appears on the display.
The display changes to show the current setting for DIGITAL 1 terminal.
2.Press CONTROL UP 5/DOWN ° to select the appropriate digital terminal setting.
•Each time you press the button, the display changes to show the following:
CT SETTING
CONTROL
DOWN UP
•Low frequency effect attenuator is not valid for the DVD MULTI playback mode.
•This function takes effect only when the Dolby Digital or DTS Digital Surround sounds with LFE signal comes in (with “SUBWOOFER” set to “YES”).
1:DVD Ò1: MD** Ò1: CDR Ò1: TV (or DBS* ) Ò
1:CD Ò(back to the beginning)
*If you have changed the source name from “TV” to “DBS,” “DBS” appears (see page 16).
**Change the source name to “MD” for TAPE/MD jacks when you use an MD recorder (see page 16).
To set the DIGITAL 2/3/4 terminals:
1. Press SETTING again until
T SETTING
DIGITAL 2/3/4 terminals' setting appears on the display.
The display changes to show the current settings.
DIGITAL 2 terminal setting
DIGITAL 3 terminal setting DIGITAL 4 terminal setting
19