Using the Dolby Digital and Dolby Pro Logic Modes

Once you have adjusted the Dolby Digital and Dolby Pro Logic modes, this receiver memorizes adjustment for each mode.

To activate the Dolby Digital and Dolby Pro Logic modes, follow the procedure below.

From the remote control:

1. Select and play the source encoded with Dolby Digital (bearing the mark ) or with Dolby Surround (bearing the mark DOLBY SURROUND ).

D I G I T A L

When you play back the source encoded with Dolby Digital and select the digital input for that source, the ÙDIGITAL indicator lights up on the display.

2. Press SURROUND MODE repeatedly until “PRO LOGIC”

SURROUND

or “DOLBY DIGITAL” appears on the display.

MODE

 

Dolby Digital or Dolby Pro Logic is automatically selected according to the source being played back.

When Dolby Pro Logic is selected, the lamp on the DOLBY SURROUND button (on the front panel) lights red.

When Dolby Digital is selected, the lamp on the DOLBY SURROUND button (on the front panel) lights green.

Each time you press the button, the DSP modes change as follows:

When the digital input is selected to play the source encoded with Dolby Digital:

DOLBY DIGITAL DIG-THEATER

OFF 3D DIGITAL HEADPHONE

For other sources:

PRO LOGIC THEATER LIVE CLUB DANCE CLUB HALL

OFF

PAVILION

3D THEATER 3D DRAMA 3D ACTION HEADPHONE

If you need to make any adjustment, go to the following steps.

3. Press SOUND CONTROL.

SOUND

10 keys are activated for sound adjustments.

CONTROL

 

 

Continued to the next page.

English

Notes:

To enjoy the software encoded with Dolby Digital, you must connect the source component using the digital terminal on the rear of this receiver.

When the signals come into this receiver through the analog connection from the source component, “PRO LOGIC” is automatically selected.

The Surround mode is not used with the other DSP modes such as the DAP mode and 3D-PHONIC mode. When the Surround mode is turned on, the other DSP mode, if used, will be turned off.

Notes on the indications:

The PRO LOGIC indicator lights up when the Dolby Pro Logic decoder built in this receiver is activated.

The Dolby Pro Logic decoder is used not only for the analog sources but also for the sources encoded with Dolby Digital in the following cases:

When only front channel signals are encoded.

When front channel and monaural rear channel

signals are encoded. While the Dolby Pro Logic is activated for this type of Dolby Digital source, the Ù DIGITAL indicator goes off.

40

Page 45
Image 45
JVC RX-884RBK manual Using the Dolby Digital and Dolby Pro Logic Modes, Press Surround Mode repeatedly until PRO Logic