JVC RX-884RBK One Touch Operation, To store the sound settings, To recall the sound settings

English

One Touch Operation

This receiver can memorize the optimum sound settings for each playing source.

About the One Touch Operation

JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.

The following can be stored for each source:

•Volume level (see page 15)

•Input attenuator mode (see page 17)

•Subwoofer output level (see page 17)

•Input mode (see page 18)

•Balance (see page 19)

•Loudness (see page 19)

•SEA modes (see page 32)

•DSP modes

–3D-PHONIC mode settings (see page 35)

–DAP mode settings (see page 38)

–Surround mode settings (see page 40 and 43)

Note:

If the source is FM or AM (MW/ LW), you can assign a different setting for each band.

Using the One Touch Operation

On the front panel only:

To store the sound settings

1.Press ONE TOUCH OPERATION.

The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled.

2.Adjust the sound using the functions listed above. The newly adjusted settings are memorized.

To recall the sound settings

With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source is recalled when the source is selected.

To cancel the One Touch Operation function

Press ONE TOUCH OPERATION so that the lamp goes off. (Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)

ONETOUCHOPERATION

ONETOUCHOPERATION

23